Panasonic DIGA DMR-ES15, Operating Instructions Manual

Page: 8 / 104

RQT8318
8
8
STEP 1 Connection
• Before connection, turn off all equipment and read the appropriate operating instructions.
• Select the connection pattern that matches your environment from patterns A-D. Confirm connections not listed below with your
dealer.
Make sure to use the pair of supplied RF coaxial cables
Use the pair of supplied RF coaxial cables only when you make connections to the unit through the RF IN and RF OUT terminals. Striping may
appear and disrupt images on the TV if you use different cables for connection.
Using a fully wired 21-pin Scart cable
• You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television ( ➔ page 38).
• You can enjoy high-quality viewing by connecting the unit to an RGB compatible television ( ➔ page 50).
“AV1 Output” in the Setup menu ( ➔ page 40)
Connecting a television
Connecting a television and VCR
Required setting
VHF/UHF
RF IN AV IN
4 1 3 2
Television’s rear panel
This unit’s rear panel
Fully wired 21-pin
Scart cable
RF coaxial cable
(included)
To the aerial
Aerial
cable
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
Connect only after all other
connections are complete.
Connecting a terminal other than
the 21-pin Scart terminal
( ➔ page 10)
RF coaxial
cable
(included)
VHF/UHF
RF IN AV IN
VHF/UHF RF OUT
RF IN
AV OUT
1
5
3
4 6
2
Television’s rear panel
This unit’s rear panel
VCR’s rear panel
To the aerial
Aerial cable 21-pin Scart cable
RF coaxial cable
(included)
Connect the unit directly to the television
Video signals fed through video cassette recorders will
be affected by copyright protection systems and the
picture will not be shown correctly on the television.
Television
This unit
VCR
Television
VCR
This unit
Fully wired 21-pin
Scart cable
RF coaxial cable
(included)
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
Connect only after all other
connections are complete.
Connecting a terminal other than
the 21-pin Scart terminal
( ➔ page 10)
“AV2 Input” and “AV2 Connection” settings in the
Setup menu (
➔
page 41)
Required setting