5
Part Names
REMOTE CONTROLLER
1
2
3
6
8
9
5
7
10
11
12
14
15
16
17
13
4
1 remote controller can control a group of up to 8 indoor units.
1. Operation Display
Displays the operation status. (The
figure shows all the statuses.)
2. Start/Stop button
Pressing this button once starts and
pressing again stops the operation.
3. Fan speed button
Press to change the fan speed.
4. Flap button
Press to change the flap direction.
5. ECONAVI button
ECONAVI
Press to set ECONAVI.
6. nanoe™ X button
nanoeX
Press to set nanoe™ X.
7. Ventilation button
Use this when connected to an
aftermarket fan.
8. Clock button
Use this to set the clock.
9. Cover
Press at the top center and then slide
down.
10. Transmitter
11. Temperature setting buttons
raises the temperature setting
1 °C at a time.
lowers the temperature setting
1 °C at a time.
12. Mode select button
Press to switch the operation mode.
13. Energy saving button
Press to enable or disable energy
saving.
14. Filter button
Press to turn off the filter lamp on the
receiver.
15. Timer setting buttons
/
/
/
/
/
Use for operating with a timer.
16. RC reset button
RC
RESET
Use this button after changing the
batteries.
17. RC address button
RC
ADR
Press to set addresses.
From this page, the names of
remote controller’s buttons will be
indicated with the above illustrations.
E.g.: Start/Stop button
CZ-RWS3_QRG.indd 5
2018/05/30 10:34:02
