Panasonic CS-PU9XKH-8M Operating Instructions Manual Download

Page: 24 / 40

Safety Precautions

WARNING

This appliance is

lled with R32

(mild

ammable refrigerant).

If the refrigerant is leaked and exposed to
an external ignition source, there is a risk
of

re.

Indoor unit and outdoor unit

The appliance shall be installed, and/or
operated in a room with

oor area larger

than Amin (m²) and keep away from ignition
sources, such as heat/sparks/open

ame or

hazardous areas such as gas appliances, gas
cooking, reticulated gas supply systems or
electric cooking appliances, etc.(Refer to Table
A of Installation instructions table for Amin (m²))

Be aware that refrigerant may not contain an
odour, highly recommended to ensure suitable

ammable refrigerant gas detectors are

present, operating and able to warn of a leak.

Keep any required ventilation openings clear of
obstruction.

Do not pierce or burn as the appliance is
pressurized. Do not expose the appliance to
heat,

ame, sparks, or other sources of ignition.

Else it may explode and cause injury or death.

Precaution for using R32 refrigerant

The basic installation work procedures are the same as
conventional refrigerant (R410A, R22) models.

Since the working pressure is higher than that
of refrigerant R22 models, some of the piping
and installation and service tools are special.
Especially, when replacing a refrigerant R22
model with a new refrigerant R32 model,
always replace the conventional piping and

are nuts with the R32 and R410A piping and

are nuts on the outdoor unit side.

For R32 and R410A, the same

are nut on the

outdoor unit side and pipe can be used.

The mixing of different refrigerants within
a system is prohibited. Models that use
refrigerant R32 and R410A have a different
charging port thread diameter to prevent
erroneous charging with refrigerant R22 and
for safety.
Therefore, check beforehand. [The charging port
thread diameter for R32 and R410A is 1/2 inch.]

Must always ensure that foreign matter (oil,
water, etc.) does not enter the piping. Also,
when storing the piping, securely seal the
opening by pinching, taping, etc. (Handling of
R32 is similar to R410A.)
• Operation, maintenance, repairing and

refrigerant recovery should be carried
out by trained and certi

ed personnel in

the use of

ammable refrigerants and as

recommended by the manufacturer. Any
personnel conducting an operation, servicing
or maintenance on a system or associated
parts of the equipment should be trained and
certi

ed.

• Any part of refrigerating circuit (evaporators,

air coolers, AHU, condensers or liquid
receivers) or piping should not be located in
the proximity of heat sources, open

ames,

operating gas appliance or an operating
electric heater.

• The user/owner or their authorised

representative shall regularly check the
alarms, mechanical ventilation and detectors,
at least once a year, where as required by
national regulations, to ensure their correct
functioning.

• A logbook shall be maintained. The results

of these checks shall be recorded in the
logbook.

• In case of ventilations in occupied spaces

shall be checked to con

rm no obstruction.

• Before a new refrigerating system is put

into service, the person responsible for
placing the system in operation should
ensure that trained and certi

ed operating

personnel are instructed on the basis of the
instruction manual about the construction,
supervision, operation and maintenance of
the refrigerating system, as well as the safety
measures to be observed, and the properties
and handling of the refrigerant used.

• The general requirement of trained and

certi

ed personnel are indicated as below:

a) Knowledge of legislation, regulations

and standards relating to

ammable

refrigerants; and,

b) Detailed knowledge of and skills in

handling

ammable refrigerants, personal

protective equipment, refrigerant leakage
prevention, handling of cylinders, charging,
leak detection, recovery and disposal; and,

c) Able to understand and to apply in practice