Panasonic CS-PC30JKF, Service Manual

Page: 41 / 68

41
After AUTO OFF/ON button is pressed, the 20 seconds counter for Remote Control Receiving Sound OFF/ON mode is
restarted.
14.2. Remote Control Button
14.2.1. SET
• To change the type of remote control transmission signal (there are totally four types of transmission codes).
- Modify the jumper (back of PCB) & connector (front of PCB) at remote control PCB.
- Press with pointer for more than 10 seconds.
- Face the transmitter towards indoor unit receiver and press the timer SET button (to send the signal) or if the timer SET
button is not pressed for 30 seconds, the setting mode is cancelled.
- Press timer CANCEL button to exit the setting mode.
14.2.2. CLOCK
• To change the remote control’s clock-hour and minute.
- Press once to enter the clock setting mode.
- Use timer increment button timer decrement button to change the time.
- Press once again to exit the setting mode.
• To change the time format (24 hours & 12 hours timer display).
- Press for more than 5 seconds.
14.2.3. RESET
• To clear and restore the remote control setting to factory default.
- Press for once to clear the memory.
14.2.4. TIMER “ ”
• Press continuously for 5 seconds, LED intensity for Remote Control dimmer code is transmitted.
• Above condition will not happen when Timer is set.
14.2.5. TIMER “ ”
• Press continuously for 10 seconds, set the operation and display changes as Celsius or Fahrenheit.
• Above condition will not happen when Timer is set.