Panasonic CS-CE12NKE, Service Manual

Page: 36 / 87

36
13.1.4 Compressor Overheating Prevention Control
š
Instructed frequency for compressor operation will be regulated by compressor discharge temperature. The
changes of frequency are as below.
š
If compressor discharge temperature exceeds 103°C, compressor will be stopped, occurs 4 times per 20 minutes,
timer LED will be blinking. (“F97” is indicated.)
13.1.5 Low Pressure Prevention Control (Gas Leakage Detection)
š
Control start conditions
o
For 5 minutes, the compressor continuously operates and outdoor total current is between 0.6A and 1.15A.
o
During Cooling and Soft Dry operations:
Indoor suction temperature - indoor piping temperature is below 4°C.
o
During Heating operations :
Indoor piping temperature - indoor suction is under 5°C.
š
Control contents
o
Compressor stops (and restart after 3 minutes).
o
If the conditions above happen 2 times within 20 minutes, the unit will:
ƒ Stop operation.
ƒ Timer LED blinks and “F91” indicated.
13.1.6 Low Frequency Protection Control 1
š
When the compressor operate at frequency lower than 24 Hz continued for 240 minutes, the operation frequency
will be changed to 23 Hz for 2 minutes.
13.1.7 Low Frequency Protection Control 2
š
When all the below conditions comply, the compressor frequency will change to lower frequency.
Temperature, T, for: Cooling/Soft Dry Heating
Indoor intake air (°C) T < 14 or T ≥ 30 T < 14 or T ≥ 28
Outdoor air (°C) T < 13 or T ≥ 38 T < 4 or T ≥ 24
Indoor heat exchanger (°C) T < 30 T < 0