Panasonic CQ-VX220W, Installation Instructions Manual

Page: 4 / 20

3
4
CQ-VX220W
English
Installation
Preparation
Dashboard Installation
¡
Before installation, check the radio operation with
antenna and speakers.
¡
Disconnect the cable from the negative (–) battery ter-
minal (see caution below).
¡
The unit should be installed in a horizontal position
with the front end up at a convenient angle, but not
more than 30°.
Installation Opening
The unit can be installed in any dashboard having an
opening as shown below. The dashboard should be 4.5
mm – 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional
installer, if possible.
In case of difficulty, please consult your nearest author-
ized Panasonic Service Center.
1. This system is to be used only in a 12 V DC battery
system (car) with negative ground.
2. Follow the electrical connections carefully (
a
page
10-17). Failure to do so may result in damage to the
unit.
3. Connect the power lead after all other connections are
made.
4. Be sure to connect the battery lead (yellow) to the pos-
itive terminal (+) of the battery or fuse block (BAT) ter-
minal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before con-
necting it to this unit.
0 – 30°
182 mm
53 mm
Caution
¡
Do not disconnect the battery terminals of a car with
trip or navigational computer since all user settings
stored in memory will be lost. Instead take extra
care with installing the unit to prevent shorts.
Caution
¡
Please follow the laws and regulations of your
province or country for installation of the unit.
¡
When bending the mounting tab of the mounting
collar with a screwdriver, be careful not to injure
your hands and fingers.
¡
We strongly recommend you to wear gloves for
installation work to protect yourself from injuries.
VX220W̲II̲01̲eng.qxd 09.2.24 7:21 PM ページ4