SPEED
ILLUMINATION
SIDE BRAKE
REVERSE
P
R
N
D
2
L
VIDEO-OUT
S.W-OUT
AV-IN
PRE-OUT FRONT
ACC 3 A
3 A
ANT CONT MAX 0.1 A
BATTERY 15 A
BATTERY 5 A
5 A
FRONT L
FRONT R
AMP CONT MAX 0.1 A
REAR L
REAR R
PRE-OUT REAR
REMOTE-OUT
Electrical connections
CN-NVD905U (Rear)
To prevent from damage to the unit, be sure to follow the wiring diagrams below.
Be sure to fully plug in the connectors. Secure them with clamps and tapes.
All other installation methods require the use of dedicated metal fi ttings. Consult with a qualifi ed servicing engineer
or your dealer if other methods are required.
(R) (Red)
(L) (White)
(Yellow)
Video input terminal (AV-IN)
Connect to a VCR, camcorder or TV tuner.
(
page 13)
Video output terminal (VIDEO-OUT)
Connect to a rear monitor. (
page 12)
Radio antenna connector (RADIO ANT IN)
Motor antenna relay control lead
(Blue)
To motor antenna (Max. 100 mA)
External amplifi er control power
lead
(Blue/white stripe)
Power lead
(Red)
To ACC power, +12 V DC.
Battery lead
(Yellow)
To the car battery, cont12 V DC.
Ground lead
(Black)
To a clean, bare metallic part of the
car chassis.
Speaker connections
Do not connect more than
one speaker to one set of
speaker leads (except for
connecting to a tweeter).
Do not use a 3-wire type
speaker system having a
common earth lead.
Use ungrounded speakers
only.
Allowable input : 50 W or
more.
Impedance : 4 – 8
Use of speakers which
do not match the
specifi cations can cause
burning, smoking or
damage of the speakers.
Power connector
Front right +
(Gray)
Front right –
(Gray/black stripe)
Front left +
(White)
Front left –
(White/black stripe)
Rear right +
(Violet)
Rear right –
(Violet/black stripe)
Rear left +
(Green)
Rear left –
(Green/black stripe)
Reverse lead
(Violet/white stripe)
To the positive (+) lead of the reverse
lamp (the lamp with a clear lens that
lights when the transmission gear is
shifted into the reverse position).
Car chassis
Clip connector
Reverse lamp
Battery
Transmission gear
Bundle excess cord. Do not cut it.
Clip connector
Car chassis
Side brake (Parking brake) switch
Side brake (Parking brake) connection
lead
(Bright green)
When the side brake (parking brake) lever is
engaged, the unit is grounded by the chassis.
Clip connector
Illumination lead
(Orange/white stripe)
To the vehicle lighting power supply
GPS antenna
To an external amplifi er or a power control lead of the TV tuner.
Connect both the power control lead of the TV tuner and the
amplifi er control connector of the external amplifi er when the
TV tuner and external amplifi er are connected at the same
time.
REMOTE OUT connector
To the REMOTE IN connector of a
TV tuner
System-up connector
To external devices equipped with system-up connector.
Data 1 connector
(available in future)
Data 2 connector
(available in future)
Rear view camera
connector
Connect a rear view
camera (
page 12)
Pre-out subwoofer connector
(Mono)
To an external amplifi er.
Pre-out connector (Front)
To an external amplifi er.
Pre-out connector (Rear)
To an external amplifi er.
This lead is not intended for use with a switch actuated
power antenna.
(Yellow)
Fuse (3 A)
Fuse (5 A)
Speed Pulse Cable
(Pink)
Clip connector
Engine control computer unit (ECU)
This is a circuit protector. Do not cut it off, and be sure to connect it in the
direction of the vehicle speed reading point as is.
Vehicle speed signal lead
(Pink)
When disconnecting a locked cable, press the lock in the arrowed direction while removing the connector.
Pulling too strongly will break the connector. Check that the lock is disengaged before trying to disconnect the connector.
Power connector
Vehicle signal connector
AV connector
GPS antenna connector
AV connector
Vehicle signal connector
How to attach a clip connector
Insert the cable into
the clip connector.
Vehicle-side wiring cable
Parking brake connection
lead of this unit (Example)
Press the element
into place.
Close the cover.
This navigation system cannot be installed in a vehicle that does
not have an ACC (accessory) position on the ignition switch.
Noise fi lter
Fuse (15 A)
Refer fuse replacement to your nearest authorized Panasonic
Servicenter. Do not attempt fuse replacement by yourself.
Warning
This product is designed for operation with a negative grounded 12 V DC battery system. Never operate this product with other
battery systems, especially a 24 V DC battery system. If it is used in the wrong type of car, it may cause a fi re or an accident.
English
English
10
11
11
10
Summary of Contents for CN-NVD905U - Strada - Navigation System
Page 15: ...English 15 15...
