3.
Click [Save].
•
[Router configuration in progress to allow access from the Internet.] is displayed.
•
If you want to register with Viewnetcam.com (visit http://www.viewnetcam.com for details), select
[Register with Viewnetcam.com] before clicking [Save]. Click [Go to Viewnetcam.com Registration
page] when this button is displayed. The Viewnetcam.com website will open in a new window. Follow
the on-screen instructions to register with Viewnetcam.com.
•
When [Setup completed] is displayed, the addresses for accessing the camera over the LAN and over
the Internet are displayed.
4.
Click [To Single Camera page].
Note
•
If you have multiple cameras connected to the same network, only one of the cameras needs to be
registered with Viewnetcam.com. All cameras connected to the network can be accessed from the
Internet using your Viewnetcam.com URL (for example,
bob.viewnetcam.com
) and adding the
desired camera’s port number after the URL. Example:
http://bob.viewnetcam.com:50000
,
http://bob.viewnetcam.com:50001
, etc. Note, however, if the camera that is registered to
Viewnetcam.com is turned off and your ISP-provided global IP address changes, you will not be able
to access any of the cameras.
•
To disable Viewnetcam.com service for this camera later, access the Viewnetcam.com website (http://
www.viewnetcam.com) and cancel your registration.
Enabling [Auto Port Forwarding] using from the [UPnP] page
1.
Click the [Setup] tab.
2.
On the left side of the screen under [Basic], click [UPnP].
3.
Under [Auto Port Forwarding], select [Enable].
4.
Click [Save].
•
[Router configuration in progress to allow access from the Internet.] is displayed.
•
When [Setup completed] is displayed, the addresses for accessing the camera over the LAN and over
the Internet are displayed.
5.
Click [To Single Camera page].
Confirming that UPnP™ port forwarding is configured correctly
To confirm that the UPnP™ port forwarding has been successfully configured, follow the procedure below.
1.
Click the [Maintenance] tab.
72
Operating Instructions
4.1 Configuring Port Forwarding