B
Buffering or transferring ends, deactivation time starts. No new images will be buffered or
transferred.
C
Deactivation time ends. The camera can buffer or transfer images again.
12.
Under [Transfer Method], select the desired transfer method.
•
MPEG-4 images cannot be transferred.
–
[No Transfer, No Memory Overwrite]: Images are not transferred. Images are buffered until the
camera’s memory is full.
–
[No Transfer, Memory Overwrite]: Images are not transferred. Once the camera’s memory is full, new
images replace the old images.
–
[FTP]: After the camera is triggered, it transfers images to the specified FTP site.
–
[E-Mail]: After the camera is triggered, it sends images to the specified E-mail address.
–
[HTTP]: After the camera is triggered, it transfers images to the specified website.
13.
Under [Send Notification When Triggered], select the desired method for receiving notification when the
camera is triggered, or select [Disable].
14.
Follow the procedure below based on the settings you made under [Transfer Method] and [Send
Notification When Triggered].
a.
If you selected to not transfer images and to not send notification when the camera is triggered, click
[Save] to finish.
•
All buffered images for the selected trigger are deleted when you click [Save].
b.
If you selected to transfer images by FTP, E-mail, or HTTP, click [Next].
•
The appropriate transfer settings page is displayed.
–
For FTP transfer, see Page 37.
–
For E-mail transfer, see Page 39.
–
For HTTP transfer, see Page 42.
c.
If you selected to not transfer images, but selected to send notification, click [Next].
•
The appropriate notification settings page is displayed.
–
For E-mail notification, see Page 45.
–
For HTTP notification, see Page 48.
Operating Instructions
33
2.2 Configuring a Sensor or Motion Detection Trigger
