18
Operating tracing memory (TMEM)
The unit incorporates tracing memory (TMEM) for recording a series of
operations that were performed for a connected remote camera.
This feature allows you to duplicate the recorded operations of a remote
camera.
<Tracing memory>
Recording target
Camera numbers CAM1 to CAM10
Functions that
can be recorded
Pan, tilt, zoom, focus, iris, and white balance
mode
Recording time
Up to 5 minutes per camera
Number of
recording
memory
Up to 10 per camera
Record buttons
Number buttons [1] to [10]
z
If the MEM ENABLE button indicator is off, tracing memory
operation is not possible. Perform operation while the button
indicator is on.
z
Preset numbers PMEM 1 to 10 of the preset memory are used
as start positions at the time of recalling tracing memory so they
are overwritten when the tracing memory registration operation is
performed.
z
The last point when tracing memory is recalled may not match
that at the time of recording because of the error of movement of
the remote camera.
Taking precautions such as the following can help reduce the
error.
• Use the lens zoom at the WIDE side (wide-angle end).
• Perform pan, tilt, zoom, and focus operations slowly.
• Set a short recording time.
Execute tracing memory recalling several times to sufficiently
check the operation of the camera before you begin operation.
Notes
<Tracing memory operation section>
TMEM button
Number buttons [1] to [10]
START button [11]
STOP button [12]
MEM SETTING button
MEM DELETE button
RESTORE button
MEM STORE button
MEM ENABLE button
Registering tracing memory (STORE)
1 .
Press one of the camera selection buttons
[CAMERA SELECT/GROUP SELECT] to select the
remote camera to be operated .
2 .
Output the images to be shot to the monitor .
3 .
Press the TMEM button to turn on its indicator .
The tracing memory status appears.
The indicators of number buttons with registered tracing memory
turn on.
CAM1 TMEM
3m50s Remained.
Selected camera number
Remaining possible recording time (max . 5 m 00 s)
z
A button with no tracing memory registered does not turn on
even when it is a button with preset memory registered.
Note
4 .
Press the MEM STORE button to turn on its indicator .
5 .
Operate the PAN/TILT lever and ZOOM button to
determine the camera angle to register .
If necessary, adjust the focus, iris, and white balance as well.
6 .
Hold down one of the number buttons [1] to [10] that
has its indicator turned off to specify the tracing
memory number .
The current camera position and settings are registered to the preset
memory of the remote camera, and become the start position and
settings at the time of recalling.
The indicators of the number button that was held down and START
button [11] blink. (Recording standby state)
z
If an operation that is target for recording such as moving the PAN/
TILT lever is performed at that time, the recording standby state is
cancelled and the status returns to that of step 3.
TM05:
Standby Store.
Tracing memory number
z
If you want to register tracing memory to a button whose
indicator is on, delete the registered tracing memory and then
register the new tracing memory.
z
If a number button that already has preset memory registered
is held down, the saved preset memory will be deleted as it
will be overwritten.
Notes
