125
Limiters
The unit comes with settings (referred to as “limiters”) that
restrict the panning and tilting movement ranges.
Depending on where the unit has been installed, a subject
which the user does not wish to be shot may be present in
the movement ranges.
In a case like this, the unit’s shooting range can be limited
by setting the limiters at the positions just before the subject
which the user does not wish to be shot.
The positions of four limiters — namely, the upper, lower, left-
most and right-most limits of the travel range — can be set.
Once they have been set, the positions will not be lost even
after the power has been turned off.
The limiters can be set or released both by the wireless
remote control and controller or web setting screen.
Whatever was set or released last takes precedence.
For the controller operations, refer to the Operating
Instructions of the controller.
The settings of the limiters using the wireless remote control
will be described here.
■
Basic limiter operations
1
Press the [MENU] button.
Tap the button (rather than pressing it).
When it is pressed for 2 seconds, the camera menu will
appear.
If this happens, press the [MENU] button again for
2 seconds to clear the camera menu.
Then start again from step
1
.
2
Press the [
▲
], [
▼
], [
◄
] or [
►
] button for
2 seconds while holding down the [PRESET]
button.
The limiter for the upper limit, lower limit, left limit or right
limit is set (or released) using these direction buttons,
respectively.
The tally lamp will blink at this time.
When a limiter is set, it blinks once; when a limiter is
released, it blinks twice.
If any other button was operated between steps
1
and
2
, start again from step
1
.
Summary of Contents for AW-UN70KPC
Page 143: ...143 Memo ...
Page 144: ...Web Site http www panasonic com Panasonic Corporation 2017 ...
