Panasonic AW-UN70KPC, Operating Instructions Manual

Page: 16 / 144

16
Preset memories
The unit enables up to 100 settings for the camera direction
(panning and tilting), zoom, focus, iris, gain and white
balance to be registered in its preset memories, and called.
However, the number of settings that can be registered and
called depends on the type of wireless remote control or
controller that is used for operation.
●
The focus and iris operating modes (manual and auto
settings) are not registered.
The current focus and iris values are registered.
●
The focus and iris values can be recalled only when the
manual settings are applicable.
●
ATW, AWB A, AWB B, 3200K, 5600K or VAR is registered
as the white balance setting. The values selected when
AWB was established are recalled as the adjustment
values of AWB A or AWB B.
●
When there is a large difference in the environmental
temperature between the time of registration and the
time the setting is called, displacement of the preset
position may occur.
●
When recalling a preset with a different image
stabilization setting from when the preset was
registered, displacement in the zoom position may
occur.
●
If displacement occurs, perform registration again.
●
Manual operations, such as pan, tilt, zoom, and iris
control, can be performed while the recalling of a
preset is in progress. However, the preset actions will
be canceled.
●
If a preset is recalled while the recalling of another
preset is in progress, the current preset actions are
canceled, and the newly selected preset is recalled.
●
Nothing will occur if a preset memory number to which
a preset has not been registered is recalled.
Notes
When performing the operations
using the wireless remote control
Twelve settings (preset No.1 to No.12) can be registered and
called using the wireless remote control.
The [1] to [12] buttons correspond to the unit’s preset
memories No.1 to No.12.
●
Registering the settings in the preset memories
1
Display the picture to be shot on the monitor.
Operate the pan, tilt or zoom buttons to determine the
camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
2
While holding down the [PRESET] button, press
the button corresponding to the preset memory
number.
●
If a preset memory number with an already registered
setting has been selected, the existing setting will be
erased and replaced with the new one.
●
Calling the settings of the preset memories
1
Press the button in which the preset memory
setting has been registered.
When performing the operations using the controller
When using an AW‑RP50 or AW‑RP120:
Up to 100 entries can be registered/recalled.
For details, refer to the operating instructions for the
controller.