Panasonic AW-HS50N, Operating Instructions Manual, Page: 45 / 125

45
3. Basic operations
3-7. Switching the AUX output
3-7-1. Selecting the AUX bus material
The AUX output material is selected using the A bus and B
bus crosspoint buttons.
1
Press the AUX button to set the crosspoint
buttons to the AUX bus material selection
mode.
2
Select the material using the B bus crosspoint
buttons.
When the buttons from [1] to [5] are pressed, the
materials assigned to the corresponding XPT1 to XPT5
are selected.
When the button from [1] to [5] are pressed while the
SHIFT button is held down, the materials assigned to
the corresponding XPT6 to XPT10 are selected.
3
Select the output signal using the A bus
crosspoint buttons.
When buttons [1], [2], [3], [4] and [5] are pressed, PGM,
PVW, KEY OUT, CLN or MV are selected, respectively.
4
Press the AUX button to release the bus
selection mode for the crosspoint buttons.
PinP ON WIPE MIX
TRANSITION TYPE
KEY-F/S PinP AUX
KEY-S
AUX
PGM
6 1
PVW
7 2
KEY OUT
8 3
CLN
9 4
MV
A
SHIFT
CUT
AUTO
BKGD
B
SHIFT
KEY-F
PinP
AUX
10 5
BUS DELEGATION
KEY ON FTB ON
2
1, 4 3
3-7-2. Transitions between AUX materials
By switching between the AUX bus crosspoint buttons, the
MIX transition can be executed from one AUX material to
another AUX material for the transition duration which has
been set.
<Setting the transition duration>
[1] TIME/CBGD Menu
6. AUX BUS Trans
While the transition is underway, the indicator of the
transition source button lights, and the indicator of the
transition destination button blinks.
When the transition is completed, the indicator of the
transition source button goes off, and the indicator of the
transition destination button lights.
When another signal has been selected while a transition is
underway, the processing for the transition will continue from
the interim point.
This operation can also be enabled or disabled using this
menu item.