– 85 –
Chapter 4 Operation — Menu setting contents
[B.GAMMA RANGE]
Sets the maximum level to perform compression/expansion of dark area.
The items that can be set are as follows.
[1]
Around 20%
[2]
Around 30%
[3]
Around 40%
[KNEE]
[KNEE SW]
Enables/disables operation of the knee.
The items that can be set are as follows.
f
[ON], [OFF]
[KNEE MODE]
Sets the knee operation mode.
[D RANGE]
The dynamic range that can be represented is determined by the value of [KNEE SLOPE] in [KNEE].
The value of dynamic range that can be represented does not change even when the value of [KNEE POINT] in [KNEE] is
changed.
[PRESS]
The compression rate of the signal is determined by the value of [KNEE SLOPE] in [KNEE].
The value of dynamic range that can be represented will change when the value of [KNEE POINT] in [KNEE] is changed.
[KNEE POINT]
Sets the position of the knee point.
The items that can be set are as follows.
f
[55%] … [100%] (1% steps)
[KNEE SLOPE]
Sets the knee inclination.
The items that can be set are as follows.
f
[0]…[100]
[HLG KNEE]
[KNEE SW]
Enables/disables the operation of knee for HLG.
The items that can be set are as follows.
f
[ON], [OFF]
[KNEE POINT]
Sets the position of the knee point for HLG.
The items that can be set are as follows.
f
[55%]…[109%] (1% steps)
[KNEE SLOPE]
Sets the inclination of knee for HLG.
The items that can be set are as follows.
f
[0]…[100]
[WHITE CLIP]
[SW]
Switches the enable/disable of the white clip function.
The items that can be set are as follows.
f
[ON], [OFF]
[LEVEL]
Sets the level of the white clip.
The items that can be set are as follows.
f
[90%]…[109%]
[DETAIL]
[SW]
Switches the enable/disable of the detail function.
The items that can be set are as follows.
f
[ON], [OFF]
