Panasonic ANUJ3000, User Manual

Page: 55 / 69

External control
45
7. Using the UV.CHK screen (only available in online mode).
… Displays all UJ35 controller information in real time.
… Enables measurement calibration of optional UV sensor and set UV strength values.
・
LED status for each CH differentiated by color
・
If an error occurs, an error number is displayed
・
Panel showing error list can be displayed at any time
・
Shows measured value in real time
・
[TYPE] Displays the current TYPE (0-7).
・
[TEMP.] Constantly shows the LED temperature for each connected CH.
・
[ERROR No.] Displays error list panel.
1) “Measurement”… Shows measured UV strength of selected CH.
*When values are being changed for a CH (1–4), Set strength (1–100) is highlighted.
・
[CH SELECT] Selects the CH to be measured.
・
[Set strength (1-100%)] Enables entry of strength (%) to be measured, can be changed
during measurement.
・
[Measured value (W/cm
2
)] Shows measured value in real time.
・
Write Uploads UV entered strength (%) to UJ35 controller.
・
Low Range Sets measurement range to 0.00-9.99 W/cm
2
.
・
High Range Sets measurement range to 0.0-49.9 W/cm
2
.
・
START Starts irradiation on the selected CH.
・
STOP During irradiation, performs emergency stop.
2) “Calibration”… For the selected TYPE, corrects the UV strength for CH and STEP.
・
[CH SELECT] Selects the CH to be calibrated.
・
[Set strength (0.00-49.9W/cm
2
)] Enables entry of strength (%) to be calibrated.
・
[Measured value (W/cm
2
)] Shows measured strength in real time.
・
[Calibration strength (%)] Shows strength (%) during calibration.
・
Write Uploads UV entered strength (%) to UJ35 controller.
・
Low Range Sets measurement range to 0.00-9.99 W/cm
2
.
・
High Range Sets measurement range to 0.0-49.9 W/cm
2
.
・
START Starts irradiation for calibration.
・
STOP Performs emergency stop during calibration.
・
RESET Resets errors.
・
ERROR No. Displays error list panel.