Panasonic AJ-RC905P, Operating Instructions Manual

Page: 5 / 16

5
Features
O
The camera recorder’s menus can be set directly.
For details of the menus, refer to the operating
instructions accompanying the camera recorder.
O
The VTR part of the camera recorder can be
operated.
O
The return signal (1 channel) can be transmitted
using the analog format.
O
The power is supplied to the camera recorder and
the signals are input and output by a 26-pin multi-
cable (maximum length: 100 meters).
The amount of power which can be supplied is
subject to limitations so consult your dealer when
putting together your system.
O
The images being shot by the camera recorder can
be transmitted as analog component signals with
their high image quality intact.
Front panel
1 POWER switch
2 POWER lamp
This indicates that the main power is on.
3 MONITOR dial
This is used to adjust the level of the signals which
are output from the MONITOR connector.
4 Y/VIDEO dial
This is used to adjust the level of the signals which
are output from the Y/VIDEO connector.
5
PR dial
This is used to adjust the level of the signals which
are output from the P
R
connector.
6
PB dial
This is used to adjust the level of the signals which
are output from the P
B
connector.
7
CHROMA (MONITOR) dial
This is used to adjust the frequency response of the
signals which are output from the MONITOR
connector.
8
CHROMA (Y/VIDEO) dial
This is used to adjust the frequency response of the
signals which are output from the Y/VIDEO
connector.
<Note>
When the Y signal is output, set the dial to its
center position.
Parts and their functions
MONITOR CABLE LENGTH
SET UP
(PUSH)
POS2
POS1
POS3
POS4
PRST
POS5 SV
SS
POS6
REW FF STOP PLAY
CALL
TALLY
REC CHK START/STOP
GAIN
GAIN
GAIN FILTER
BLACK
R B
PAINTING
ENABLE
AUTO IRIS
CHECK
M.PED KNEE SLOPE
GAMMA
DETAIL
KNEE POINT
IRIS
SHUTTER
WHITE
BAL
ABB
A
B
AUTO KNEE
AWB
VTR WARNING
BAR
VTR
ENABLE
100m 50m
CHROMA
Y/VIDEO
PR
PB
POWER
PGM
RCU CAMERA
INTERCOM
MIC
BBS
PUSH
CHROMA
OFF
OFF
ON
ON
OFF
ON
1
2
6
5
4
8
3
7