81
Playback (sound)
Other
Cannot hear any sound
from the camera-
recorder’s speaker.
• You may have turned down the camera-recorder’s volume control
too far.
In the VCR mode, adjust the volume level using the AUDIO MON/
VAR .
P 49
I can hear two sets of
sound.
• You may have selected “MIX” as the 32K (12bit) AUDIO setting in
the PLAYBACK FUNCTION screen.
• If you perform audio dubbing on a tape that was recorded with
32K (12bit) selected as the AUDIO REC setting in the
RECORDING SETUP screen, you will hear the sound heard
during recording and that of the audio dubbing. You can also
listen to each sound separately.
When I performed
audio dubbing, the
original sound was
erased.
• If you perform audio dubbing on a tape that was recorded with
32K (12bit) selected as the AUDIO REC setting in the
RECORDING SETUP screen, you will hear the sound heard
during recording and that of the audio dubbing. To leave the
original sound intact, make sure that 32K (12bit) is selected when
you shoot.
P 74
Cannot remove the
cassette tape.
• Make sure the camera is supplied with power.
Make sure the AC adapter or battery is inserted correctly.
As long as the power is supplied, you can remove the cassette
without turning ON the POWER switch.
Cannot perform any
operation other than
removing the cassette.
• Condensation may have formed.
If this happens, the only operation that you will be able to perform
is to remove the cassette. Wait until the condensation has dried
out.
• When the cassette holder is closed immediately after sliding
EJECT switch to open the cassette holder, sometimes operations
other than eject cannot be performed. In this case, slide EJECT
switch again to open the cassette holder, check that the cassette
mechanism has completed ejecting operation, and then close the
cassette holder.
P 82
—
The remote control
does not work.
• The button battery in the remote control may have run out.
If the remote control fails to work even if it is operated close to the
remote control sensor of the camera-recorder, it means that the
button battery has run out. Replace it with new one.
• Make sure the remote control setting is the same for the remote
control unit and the camera-recorder.
If the REMOTE setting is different on the remote control and the
camera-recorder, the remote control will not work.
There is a rattling
sound when the
camera-recorder is
tilted back and forth.
• There are some parts of the camera that make a rattling sound in
the VCR mode or when the POWER switch is OFF. This is
normal.
—
Re
fe
re
n
ce
Summary of Contents for AGDVX100BP - DVC CAMCORDER
Page 87: ...87 MEMO Reference ...
