35
Recorded data have
become totally or partially
unusable.
Troubleshooting
(continued)
Recording
(Check this with the Toughbook-Arbitrator Front
End Software.)
• Is a P2 card inserted?
• Does the P2 card have sufficient free space?
Check the free space with the Toughbook-
Arbitrator Front End Software. Upload files and
free up space.
• Make sure that the write-protect switch of the P2
card is not set to PROTECT.
• Is the GPIO cable connected properly? Also
connect the ground line of the GPIO cable. For
details, see the installation manual.
• Are the settings for the GPIO/SERIAL port
correct? For details, see the documentation of
the Toughbook-Arbitrator Front End Software.
• Is the P2 card usable? If file information cannot
be obtained using the Toughbook-Arbitrator
Front End Software, you should format the P2
card. For information on formatting, see the
installation manual. (When you format a P2
card, all existing data on it will be erased.)
• Are there P2 cards inserted in both slots 1 and 2
while using a 16 GB or higher P2 card?
When using a 16 GB or higher P2 card, you can
only use one card.
• When using new 16 GB or higher P2 cards,
make sure that the card was formatted on a
computer that has the P2 card driver installed. If
the folders on a 16 GB or higher P2 card have
been modified on a computer or other device,
you must reformat the card.
• If the power source was interrupted or if the
power cable was disconnected during recording,
data may become corrupted. Ensure that power
is never interrupted during recording. In some
cases, it may be possible to restore corrupted
data using the Toughbook-Arbitrator Front End
Software.
Cannot start recording.