Panametrics PanaFlow XMT1000, User Manual, Page: 70 / 80

Table 9: Available measurement values and parameters
in the composite TB
Composite TB measurements
and parameters
Measure-
ment
Para-
meter
UMPU_SERIAL_NUMBER R
TOTALIZER_CMD R/W
SENSOR_SERIAL_NUMBER R
MULTIK_ACTIVE R/W
MULTIK_TYPE R/W
MULTIK_PAIRS R/W
KVINPUT_SELECTION R/W
ENABLE_ACTIVE_TW R/W
CALIBR_MODE_SELECTION R/W
PATH_ERROR_HANDLING R/W
UNIT_TYPE_DIMENSION R/W
UNIT_TYPE_TIME R/W
UNIT_TYPE_VISCOSITY R/W
UNIT_TYPE_STD_VOL R/W
SYSTEM_SERIAL_NUMBER R
FTPA_SERIAL_NUMBER R
VOLTAGE_SELECTION R/W
ATTENUATOR_SELECTION R/W
D.6.1 Clearing the totalizer
Batch totals can be controlled through foundation fieldbus
(see figure 29 below). The user can start, stop, or reset batch
totalizers by setting the option on the TOTALIZER_CMD
function of the composite transducer block . To set the
totalizers from the foundation fieldbus:
1. Verify that the gate and ground terminals on the main
PCB are connected.
2. Program the CALIBR_MODE_SELECTION parameter
on the composite transducer block to gate input .
After these steps are complete, you can control the batch
totalizer (start, stop, or reset) by selecting the desired option
on TOTALIZER_CMD and writing the changes to the meter.
No password is required for this function.
IMPORTANT:
The inventory totalizer can only be reset at the factory.
Figure 29: TOTALIZER_CMD function on composite TB
62