![background image](http://html1.mh-extra.com/html/panametrics/digitalflow-xgs868i/digitalflow-xgs868i_startup-manual_3410955037.webp)
DigitalFlow™ XGS868i Startup Guide
29
Chapter 2. Initial Setup
2.3 The XGS868i Enclosure Keypad (cont.)
When you power up the XGS868i, the display first shows the model and software version:
The meter then starts to display measured parameters.
To enter the
Keypad Program, press the
[Escape]
key, followed by the
[Enter]
key, and the
[Escape]
key again. Each
successive key must be entered within 10 seconds of the prior key.
As a guide in following the programming instructions in this chapter, the relevant portions of the Model XGS868i
menu map have been reproduced in Figure 15 on page 39
. Proceed to the following sections to enter data in the
Channel
or
GLOBL
menus.
IMPORTANT:
If the keypad has not been pressed for 10 minutes, the XGS868i exits the Keypad Program and returns to
displaying measurements. The meter retains any configuration changes that were confirmed with the
[Enter]
key, and restarts as if the operator had completed the programming cycle.
Panametrics
XGS868i Y4AS.STD
CH1 VEL E1
10.00 Ft/s
Summary of Contents for DigitalFlow XGS868i
