Panametrics DigitalFlow GC868, Programming Manual, Page: 106 / 134

Appendix C. Programming with PanaView
C-3 DigitalFlow™ GC868 Programming Manual (2-Channel)
C.3.1 Setting up
Ethernet
Communicatio-
ns
If you have selected TCP/IP in step 6 on the previous page, the Setup
Communications window appears similar to Figure C-3 below.
Figure C-3: Setup Communications for TCP/IP
1. Type in the desired Name and Timeout (in milliseconds).
2. In the
IP Address
text box, enter the IP address. If the IP address is unknown, run
the Device Discovery software utility. All units found will be identified by their MAC
address and the assigned IP address. In the
Port Number
box, enter 2101 (the
default value).
3. Click [OK] to complete data entry.
IMPORTANT: If you are using Ethernet communications, be sure the GC868 is set up
with the default communications parameters: 9600 baud, no parity,
no handshaking, 8 data bits and 1 stop bit. The port number must
match the “Enable Raw TCP access using TCP Port” assignment shown
under the
Device Discovery
“TCP Server Settings” menu
(
Configuration>Serial Ports>Port
).