PAMI Hemming Machine 99, Instructions For Use And Maintenance Manual

Page: 16 / 34

15
ADJUSTING THE STACKER
Turn selector switch “A” (fig. 6) to “NORMAL” or
“SMALL” depending on the size of pocket used.
6
A
ADJUSTING THE CONVEYOR BELT SPEED
If the pockets on the delivery conveyor belt do not lie flat, but turn upwards, you need to reduce the machine
point slightly or increase the number of stepping motor impulses (see specific paragraph below).
Likewise, if the pockets are too taut, causing uneven internal hems, adjust in the opposite fashion.
ADJUSTING THE STEPPING MOTOR IMPULSES
- Press keys and on the control panel simultaneously;
- The message appears on the display;
- Keep both keys pressed until the message changes and reads ;
- Press key until the message appears; (setting for impulse number in a single rotation);
- Use keys to enter the number of impulses required from the end fabric photocell reading;
- Press keys simultaneously to quit.
IMPORTANT: Every time the number of impulses is changed, you must switch the unit off, wait for the
control panel display to switch off and then switch the unit back on again;
"
!
"
!
P - C
I
A. P S U
C P. - -
C
+
-
D
+
-
C
+
-