PaloAlto Networks PA-5200 Seriesp, Hardware Reference Manual

Page: 39 / 60

Service the PA-5200 Series Firewall
STEP 5 | Install the replacement drive in the drive carrier.
1. Remove the replacement drive from the anstac bag and place it on an anstac
surface. Place the failed drive next to the replacement drive with the connectors facing
the same direcon.
2. Remove the four screws that hold the failed drive in the carrier and remove the drive
from the carrier.
3. Install the replacement drive in the carrier and secure it using the four screws you
removed from the failed drive.
The illustraon shows an SSD system drive and an HDD log drive; the procedure to swap the
drive is the same for both.
STEP 6 | Install the carrier with the replacement drive:
1. Ensure that the drive carrier lever is in the open posion; if it is not, press the ejector
buon on the drive carrier to release the lever and pull it out unl it is fully open.
2. Slide the carrier assembly into the empty drive bay unl it is about 1/4” (.64cm) from
being fully inserted.
3. Before fully inserng the carrier, ensure that the lever aaches to the locking mechanism
on the firewall and then close the lever to seat the carrier.
STEP 7 | Choose from the following two installaon procedures based on your findings in 4 :
• If the replacement drive is the same model number as the failed drive, connue to 8 .
• If the replacement drive is a different model number than the failed drive, connue to 9 .
PA-5200 Series Next-Gen Firewall Hardware Reference 39
©
2021 Palo Alto Networks, Inc.