- Lift the extension module over the base module so that the four locating pins align with the
four corner holes. Then lower the extension module on top of the base module so that the
four corner locating pins insert into the holes on the base module (Figure 9).
Figure 9
Four corner locating pins aligned with four corner holes
Next fasten the ten bolts with nuts with top and bottom washers to secure the base module to
the extension module (Figure 10).
Figure 10
Secure ten bolts with nuts and washers
4.2
Preparation and installation of the hoist
1. Attach the hoist bracket to the top of the extension module by placing each side of the
bracket frame holes into the positioning pins. Fasten the other hole on the bracket feet using
a bolt with nut and washer (Figure 11). This is installed in the same manner as the lifting plate
mentioned above.
Figure 11
Bracket frame secured.
Note:
Crossbar will not be attached at this step yet.
www.pall.com/biopharm
7
