ILP 25/33 Installation Manual
Rev. 1.4
- 16 -
9
Chassis and Body Preparation -
900mm [35.40“] Liftarm
-Decrease ground clearance only to clear obstructions (i.e. fuel tanks, cross members, hitches, etc.)
WITHOUT EXCEEDING MAXIMUM
“F”
dimension
of 28”.
- Minimum bed height is when truck/trailer is loaded to Maximum GVW (Gross Vehicle Weight).
-
“F” dimension: Mount and Ground clearance always relate to each other on a set floor height. If the
“F” dimension is increased for a shorter mount clearance, the ground clearance will decrease.
1) Bed Height:
Bed Height Ranges: Max=Unloaded / Min=Loaded Truck Measure from
TOP
of body floor
to ground. Vehicle must be on a flat leveled surface when measuring.
2)
“F” Dim (Mount Frame Height):
Measure from top of Mount Frame to top of body floor.
3)
“K” Dim Ref. (Mount Clearance):
Measure from rear of body to front edge of Mount Plates.
4)
“G” Dim (Ground Clearance):
Measure from bottom of Mount Frame to ground.
5)
“A” Dim (Vehicle Body Cutout):
Measure from the rear of the sill towards the front of the vehicle.
6)
“B” Dim (Vehicle Body Cutout):
Measure from top of the sill down to the ground.
7)
900mm [35.40”] Liftarm:
Measure from center to center of pivot pins.
"K"
Mount
Clearance
(Reference)
"F" Dim.
Bed Height
Max. 56"
Min. 47"
"G"
Ground
Clearance
"A"
"B"
Mount
Frame
Sill
Cutout
4"
4"
12"
G Dim = Bed Height
– F Dim. – Mount Frame Height
Never exceed any of the dimensions from the table when installing the liftgate.
*Vehicle bed heights tend to lower 3”-4” when loaded.
Mounting Dimension Table
Mounting Dimensions for
900mm [35.4
0“] Liftarm
Chassis Frame
Cutout Dimensions
Bed Height
(Landen)
F
Dim.
G
Dim.
K
Dim.
A
Dim.
B
Dim.
56
“-52“
28
“
24
“-20“
31
“
21
“
18
“
52“-47“*
26
“
22
“-17“
32
“
22“
15
“
