INSTALLATION
T6M SERIES MOBILE SERVICE MANUAL – SM/16/1.0
Page 4-4
Install the microphone rest in a convenient location using the screws provided.
Plug the microphone lead into the socket located on the underside of the front panel of the
mobile radio and fit the strain relief grommet into place.
Install the speaker in a location where it can be easily heard, using the mounting bracket and
screws provided.
4.3 Radio Unit Connections
Figure 4-2 Mobile Connections
4.4 Power Cable Installation
Where possible disconnect the vehicles main positive DC supply cable from the battery to
prevent damage from accidental short circuits during the installation.
In some cases this may cause problems with the loss of engine management information or
radio key codes. Check with the customer to see if this is the case before disconnecting the
battery. Power saver devices are available which plug into the cigar lighter or accessories
socket and prevent loss of memory information on vehicle systems.
Route the power cable to the battery. If there is excess cable, cut it to the required length. If it
is necessary to drill a hole in the firewall or bulkhead to route the cable through then fit a
grommet and seal it when the installation is complete.
-
+
MOBILE UNIT
BATTERY
SPEAKER
FUSE HOLDER
ANTENNA
POWER SUPPLY
CONNECTOR
BNC
CONNECTOR
MICROPHONE
FIELD PROGRAMMER
Ignition Sense
