SCAHTUM-03
16
SCA 1200HT User Manual
7: Unpacking, Inspecting and Installing your SCA
THE SCA SHOULD BE INSTALLED BY AN AUTHORIZED DISTRIBUTOR ONLY.
INSTALLATION BY THE USER MAY VOID THE WARRANTY.
Before removing your SCA from its packaging, completely read this manual. Follow all
safety recommendations while unpacking, installing and operating the system.
7.1: Package Contents
The SCA is shipped with the following contents:
SCA System (1)
Large Part Basket (1)
Small Part Basket (1)
Quick Reference Card (1)
Power Cords:
110V North America std.
220V Europe std.
User’s Manual & Warranty (1)
If any parts are missing you should contact customer support immediately.
7.2: Unpacking
Place the package on a stable horizontal surface and check inside for the
items listed above. Some items may be stored inside the tank for
shipping. Remove everything from the SCA unit itself before lifting the
SCA from the shipping container.
Unit weight is approximately 64 lb/29 kg. Two or more people should
lift the unit out of the packaging and place it on a table or cart.
7.3: Inspecting Unit
Carefully inspect the unit for damage during shipping. If any damage is found DO NOT
ATTEMPT TO OPERATE THE UNIT. Contact technical support immediately for
assistance.
7.4: Installation
1.
Place the Large Part Basket into the tank after ensuring all packing material has
been removed.
2.
Close the lid over the tank.
3.
Attach the power cord to the system and then to a
grounded wall socket. Only use a power cord
provided by the manufacturer.
4.
Press the ON/OFF Power Switch and check to
make sure that the display control panel lights up.
5.
Turn the unit off.
6.
Make sure the drain valve is in the closed
position. Remove the blue plastic cap from the
drain tube before use.
7.
Complete the online registration form at
www.SupportRemoval.com.
Figure 8: Power Switch and Plug Locations
Power Switch
Drain Tube
Drain Valve
(closed position)
Power Cord
Receptacle
