PACOM PNVR32-RMT, User Manual, Page: 20 / 160

User’s Manual
12
 Recording service port (default: 11002): You need to do port forwarding for the recording service port to
see recorded data in the NVR system.
 Monitoring service port (default: 11004): You need to do port forwarding for the monitoring service port
to receive event information from DVRs and IP products.
DVRNS
 Server Address , Server Port : Enter the IP address
(domain name) and port number of the DVRNS server
to register the NVR system.
 Use DVRNS : Allows you to enter the name
instead of the IP address of the NVR system by using
the DVRNS function when connecting to the NVR
system.
− Use NAT : Check the box when the NVR system uses a NAT (Network Address Translation) device
for network connection.
− Name : Enter the NVR system name to be registered on the DVRNS server. Check whether or not
the name is available by clicking the
Check
button.
NOTES:
 The DVRNS (DVR Name Service) function allows the NVR system to use dynamic IP addresses for remote
connection. When using this function, you can access the NVR system remotely by using the NVR system
name instead of its IP address. For the DVRNS function to work properly, the NVR system should be
registered on the DVRNS server.
 When LAN settings are changed, set up the DVRNS settings after saving your LAN changes by clicking
the OK button.
 You will need to get the IP address or domain name of the DVRNS server from your network administrator.
You can use the domain name instead of IP address if you set up the DNS server during the IP Address
setup.
 When using a NAT (Network Address Translation) device, refer to the NAT manufacturer’s instructions
for the proper network settings.
 The NVR system name you entered in the Name field should be checked by clicking the Check button,
otherwise the DVRNS changes will not be saved. When entering no name or a name already registered
on the DVRNS server, an error message displays.
SSL
 Use SSL : Allows you to enhance the security of data
transferred between services of the SiRiS program
by using the SSL (Secure Sockets Layer) protocol.
Using the SSL function might cause congestion in the
NVR system depending on the security level. Log in
the SiRiS program again after you change the setting.
When the setting is changed, all services that are
currently connected to the administration service
reconnect, and the SiRiS Setup and SiRiS Client
programs are logged out.