PACOM 8-Channel, User Manual

Page: 30 / 84

User’s Manual
22
Highlight the first box beside
Remote Watch
–
bps/ips
.
Press the
Up
and
Down
arrow buttons to set the Transfer
Speed from 50Kbps to 100Mbps.
Highlight the second box beside
Remote Watch
–
bps/ips
.
You can select the unit of measure for the transfer speed
between:
bps
and
ips
. Press the button to set the transfer
speed.
Highlight the box beside
Remote Watch
–
Quality
and press
the button. You can select the Quality from:
Very High
,
High
,
Standard
and
Basic
. Press the button to set the
Quality.
Figure 21 — Network setup screen.
Highlight the box beside
Remote Watch
–
Resolution
and press the button. You can select the Resolution from:
High (Half D1)
and
Standard (CIF)
. Press the button to set the Resolution.
NOTE: The higher Quality and Resolution settings require higher Transfer Speed settings. The transfer speed
you set is the maximum speed. Depending on the network environment, this speed may not be achieved.
You can limit the network bandwidth settings so that system does not consume too much network bandwidth. Highlight the
box beside
Network Bandwidth Limit
and press the
Up
and
Down
arrow buttons to set the desired maximum bandwidth
from 10Kbps to 100Mbps.
NOTE: When limiting the network bandwidth, the remote watch image on the PC running RAS or WebGuard
might not be displayed properly.
The DVR supports two-way audio communication between a local system and a PC running RAS. Highlighting the box
beside
Remote Audio Channel
and pressing the button allows you to select the audio channel that sends audio to the
remote site. Selecting
Select From RAS
will send audio of the channel selected from RAS.
NOTE: Depending on network conditions, audio might be interrupted or out of synchronization during
transmission.
Highlight
Enable SSL for Transferring Data
and press the button to toggle between On and Off. When it is On,
the security of data except video and audio transmitted for remote monitoring or remote recording can be enhanced
by using the SSL (Secure Sockets Layer) authentication. When using the SSL function, the DVR cannot be connected
with a remote program or a network keyboard which does not support the SSL function.
CAUTION: The remote connection will be disconnected temporarily after changing the SSL settings.
NOTE: While the SSL function is enabled, the network transfer speed you selected may not be achieved.
This product includes software developed by the OpenSSL Project for use in the OpenSSL Toolkit
(http://www.openssl.org/).
Highlight the
LAN
tab, and the LAN screen displays.
Figure 22 — LAN (Manual) setup screen.
Highlight the box beside
Type
and press the button. You
can select the type of network configuration from:
Manual
,
DHCP
and
ADSL (with PPPoE)
. Select the desired type
and press the button.
Selecting
Manual
from the Type allows you to set up LAN
parameters manually.
Change the numbers by highlighting them and using the
Up
and
Down
arrow buttons to increase or decrease the number.
The factory default LAN settings are:
IP Address: 192.168.1.129
Gateway: 192.168.1.254
Subnet Mask: 255.255.255.0