Have you done these important things?
Please be sure you have done the following:
The platform must be round and the same diameter as your yurt.
The screw in the tip of each rafter should be installed to keep the rafter from lifting off the
tension cable.
(Page 9)
The rafters over the door should be secured to the top door sill with the screws provided.
(Page 10)
If the Snow & Wind Kit was purchased, the cables in the rafters zigzag in
opposite
directions so they pull against each other and both cables need to have the same amount of
tension on them.
(Page 12 and diagram page 13)
If the Snow & Wind Kit was purchased, two screws need to be installed through the lattice
wall into the back of each rafter support.
(Page 11)
The gap between the side cover and grommet strip on the top cover needs to be a consistent
1” before securing the bottom of the side cover to the platform.
(Page 24)
After making sure the gap is 1”, be sure the cord in the grommet strip (under the valance) is
securely tied to the last grommet on the top cover next to the door.
(Page 24)
The cord that is laced through the grommets at the bottom of the top cover valance needs to
be pulled
as tight as possible
and secured at the door frame.
(Page 28)
If the dome opener is purchased it is
extremely important
to make sure the opener
spindle is installed correctly to avoid breaking the dome skylight.
(Page 32)
When cleaning the dome skylight
DO NOT USE
glass cleaners! See care recommendations
on
page 50.
Remember that this manual includes a care and maintenance section that should be referred
to periodically.
If you do not fully understand the set up process call us at 1-800-944-0240.
Summary of Contents for 20' Yurt
Page 62: ......
