QUICK START GUIDE:
Caution: Please do not run the algae reactor dry! Failure to do so will cause per-
manent damage.
1). Carefully unpack the reactor and all of the contents.
2). Plug the power cable into the power supply and the other end into a standard
110-220 volt wall receptacle.
3). Connect the power supply to the LED inner segment. Ensure the power supply
is away and protected from the water source. Check that all LEDs light properly.
4). Connect feed pump to the bottom inlet of the reactor. Use flexible or hard
plumbing piping for inlet and outlet of the reactor.
5). Open the reactor and pull out the inner segment, then place small clumps of
algae on each layer.
6). Carefully place the inner segment back inside reactor, and secure lid by twisting
and tightening the screws.
7). Use a controller or timer to run the reactor on a reverse daylight schedule. For
best results the reactor should be turned on 1h before the main display lights go
on and remain on 1h after display lights are turned off.
8). Turn on the flow to the reactor and check for any leaks.
9). If you are using calcium reactor - connect effluent tubing(output from calcium
reactor) to proper port on AlR-PRO Algae reactor. It will help remove the rest of
carbon dioxide from effluent and increase pH in final effluent(also overally in main
tank/aquarium). If calcium reactor is not used - valve on Calcium port should be
completly closed.
10). Remember about inspecting your reactor every week or two and removing
some fast growin algea. To much them inside will block flow and decrease reactor
efficiency.
