The optional blower kit (Part #: 11140001) is equipped with a three prong power cord and may be installed at
any time. Follow the installation instructions supplied with the kit. Route power supply cord away from heater.
Electrical rating: 115 volts AC-1.02 amps.
Fan output rating: 160 CFM
Blower Operation
Proper blower speed matched with air control setting will ensure peak performance from your stove. Operate
as follows:
• Air control set to "L" (low), operate blower speed control on "Low". Failure to turn the blower to low may
result in the unit going out.
• Air control set between "L" and "H" (low and high), operate blower speed control at desired setting.
Automatic:
To operate the blower automatically, set the rocker switch on the side of the fan housing to
"Auto" and set the speed control to your desired setting. This will allow the fan to turn on as the stove heats
up to operating temperature. It will also shut the blower off after the fire has gone out and the unit has cooled
to below a useful heat output range.
Manual:
To manually operate the blower, set the rocker switch to "Man" and set the speed control to your
desired setting. This will bypass the temperature sensing device and allow full control of the blower. Switching
from "Auto" to "Man" or selecting speed may be done anytime.
Note: The Blower will not shut off until it is manually turned off.
Optional Blower
Firebrick Installation
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
C
C
C
D
B
ITEM
DIMENSIONS
A
9” X 4 1/2” X 1 1/4”
(230 mm x 115 mm x 32 mm)
B
2” X 9” X 1 1/4”
(57 mm x 230 mm x 32 mm)
C
4 1/2" X 4 1/2” X 1 1/4” (115 mm x 115 mm x 32 mm)
D
2" X 4 1/2” X 1 1/4”
(57mm x 115 mm x 32 mm)
Figure 14: NEO 2.5 freestanding brick layout.
Neo 2.5 LE_14119-32
23
100003380
