Chimney connector pipe should be disconnected from stove to clean and inspect. Only if this is not possible
should you remove baffle assembly.
DO NOT OPERATE WITH BAFFLE ASSEMBLY, TUBES OR INSULATION REMOVED.
Baffle Removal
1. Slide the Ceramic Board located above the tubes towards the front of the stove. Remove retaining pin at
the back of the firebox, just under the baffle.
2. Lift the Baffle up to disconnect from the Baffle supply tube.
3. Move the Baffle to one side then tilt it sideways to drop down and remove from firebox. You may need to
remove the opposite side brick rail to allow the Baffle to drop down. - To remove the Brick Rail, remove
the brick directly under it then lift the rail up and inward to clear the locating pins
4. Inspect the gasket between baffle and supply tube. If necessary, replace with gasket (prt#80000365)
available from your Pacific Energy dealer.
5. Re-install baffle assembly in reverse order. The two side pieces of blanket insulation must be tight against
the side rails. The Ceramic Board on top of the tubes must be pushed back tight against the Baffle.
Baffle / Tube Removal
Tube / Baffle Board R
emoval
1. With a set of vise-grips, grasp the front baffle tube on the right, slightly away from the baffle air assembly.
While squeezing tightly, use a hammer to hit the pliers and pull the tube to the right to disengage the tube
from the hole on the left. Allow the tube to hang freely from the hole on the right.
2. Repeat step #1 for rear baffle tube.
3. Grasp the front edge of the baffle board and pull forward. Guide the board down and through the door
opening.
Caution - Baffle Board material is very fragile.
Installation
1. With the holes facing down/forward and the notch to the left side, insert a baffle tube into the hole in the
baffle air channel on the right at an angle and then raise and insert into the opposite hole on the left side
baffle air assembly.
2. With a set of vise-grips, grasp the baffle tube on the left, slightly away from the baffle air assembly. While
squeezing tightly, use a hammer to hit the pliers and push the tube to the left to engage the tube in the
hole on the left.
3. With the rear tube installed, Insert the baffle board above the tube, between the tube and the side hold
down tabs.
4. Repeat steps #1 & #2 with the remaining baffle tube, being careful not to damage the board.
5. Slide the baffle board back until the lower edge is tight against the baffle.
ALT 4-LE 040523-28
11
100003978
