PowerHalt is a registered trademark of Pacbrake Co.
8
PH2 - AUTO / MANUAL / ELECTRIC WITH PULL CABLE(S)
L6372
L6372_REV6.17.04.2018
ECN 1-1859
16
MAGNETIC PICK UP INSTALLATION
Inspect the engine for a suitable location on the Bell Housing
for a magnetic pick-up. Ensure this location is accessible and
centered over the flywheel ring gears.
NOTE: If a flywheel inspection chamber is present then use this
to determine the center position for drilling.
Drill and tap as required based on your magnetic pick-up
Suggested Torque specifications below.
Suggested Torque:
Magnetic pick-up diameter
3
⁄
8
-
24 is 4
ft-lbs
Magnetic pick-up diameter
5
⁄
8
-18 is 20
ft-lbs
Magnetic pick-up diameter
3
⁄
4
- 16 is 62 ft-lbs
Install the provided magnetic pick-up (mag) into the new tapped
hole on the Bell Housing. Thread in all the way until the mag
contacts the ring gear. Once this happens back off a ½ turn. Use
hand tap to clean port threads if necessary. Tighten the jam nut
securely as per the suggested torque.
Route the mag pick-up wiring to the mag location on your engine
and connect the weather-pack connector.
NOTE: Secure the wiring harness with the provided tie straps.
Away from any moving parts or high heat sources.
17
VALVE WIRING INSTALLATION
Route the harness leg with 2 pin Metri-Pak to the PowerHalt
valve. Connect the connector to the mating connector on
the valve.
NOTE: Secure the wiring harness with the provided tie straps
away from any moving parts or high heat sources.
