Stinger ELEV8 or HEIGH10
®
Radio Replacement Kit
for Jeep Wrangler JL and Jeep Gladiator JT Vehicles
SRK-JW18EH
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 7
Rev: v3
Date:100620
Section 2: Radio Unit Mounting Preparation (cont.)
Section 3: Radio Unit Harness Connections and Preparation
Step 3
Step 2
Step 1
Connect the PL1 interface module
connector labeled “PAC LINK” into
the 3-pin port on the PAC-LINK
interface module.
OR
AMPLIFIED
NON-AMPLIFIED
Connect the four CH4A-JW18
interface module connectors
into the appropriate ports on the
CH4A-JW18 interface module.
Ensure that the 12-pin connector
is plugged into the correct audio
output port (this depends on if the
vehicle is equipped with a factory
amplifier or not).
Connect the two Stinger radio
module connectors which
are labeled “16PIN RADIO”
and “10PIN RADIO” into the
appropriate ports on the Stinger
radio module.
Part One: Main Harness Connections (RPK-JW18-HAR)
Part Three: Assembling the Screen Mounting Panel
Step 2
Step 1
Lay the radio screen into the
mounting panel and secure it to
the panel using the four M4x12
screws included in your ELEV8
or HEIGH10 box.
Install the six orange retaining
clips onto either the ELEV8 or
the HEIGH10 mounting panel
(HEIGH10 panel shown).
