APPLICATIONS
APPLICATIONS (cont.)
10. POLE PRUNER
Chain Lubrication
Level of oil in the oil container: Both before and during
your work make sure that there is always sufficient oil in
the system. To avoid damaging the bar & chain, never run
the pruner if there is no oil in the system or if the oil drops
below the “min“ mark. On average, a single filling will last
around 10 minutes depending on the number of pauses in
cutting and the loads involved.
Chain Tension
Tension of the chain, condition of the cutting elements: The sharper the chain, the easier and more
controllable it is to operate the pruner. The same also applies to the chain tension. For greater safety
you must check the chain tension before your work and at least every 10 minutes during your work.
New chains in particular tend to expand more (see
Tensioning the Chain
.)
Safe Working
Never stand under the branch you want to saw. Use special caution when working with branches
under tension and splintering wood.
Possible risk of injury caused by falling branches and catapulting pieces of wood.
When the equipment is in operation, keep other persons and animals away from the danger zone.
The equipment is not protected from electric shock through contact with high-voltage cables. Keep
a minimum distance of 10m from live cables. Electric shock can cause fatal injury. When working on
slopes always stand to the upper or left or right side of the branch you want to cut.
Hold the equipment as close as possible to your body. This will help you to keep your balance.
Always hold the equipment firmly with both hands.
Protective Clothing
Make absolutely sure to wear the appropriate, close fitting protective clothing, such as protective
pants, gloves and safety shoes. Wear hearing protection and protective goggles a safety helmet with
a face guard will provide protection against falling and recoiling branches.
24
