![background image](http://html1.mh-extra.com/html/ozito/ssb-405/ssb-405_instruction-manual_1666765016.webp)
15
Keep the ventilation vents of the tool clean at all times, if possible, prevent
foreign matter from entering the vents.
After each use, blow air through the tool housing to ensure it is free from all
dust particles which may build up. Build up of dust particles may cause the tool
to overheat and fail.
If the enclosure of the tool requires cleaning do not use solvents but a moist soft
cloth only. Never let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
The motor mount screws could work loose over time, periodically inspect and
when required tighten the screws.
Squaring the table to the Blade
Loosen the table bevel lock knob (11) to allow the saw table (7) to be
approximately at a right angle to the blade.
Place a square on the saw table (7) next to the
blade to check if the table is at a 90° angle to the
blade (Fig. 17). If not than adjustment is required,
change the bevel angle until the saw table (7) is at
a 90° angle to the blade and tighten the table
bevel lock knob (11).
Loosen the screw holding the scale pointer (Fig. 18),
move the pointer to the 0° position and tighten
the screw.
•
•
•
•
•
•
•
maintenance
Fig. 17
Fig. 18