aSSemBly
8
unpacking
Open carton and remove top packing material
Carefully lift the variable speed scroll saw from the packaging and place it on a
level work surface.
By applying paste wax (not included) in thin coats to the entire saw table (7) will
allow the work piece to glide smoothly across the work surface. Let dry then
use a clean piece of cloth to buff the surface out. Reapply as necessary for a
smooth finish.
mounting to a workbench
The variable speed scroll saw features four holes in the base for mounting to a
workbench or worktable. This is recommended to gain maximum stability and
reduce noise and vibration. It is best to attached the variable speed scroll saw to a
stable, flat surface at a convenient working height. Each hole in the base should be
bolted securely using bolts, lock washers and nuts (not supplied).
If you are using the variable speed scroll saw in several different places, it is
recommended you fasten it permanently to a mounting board that can be clamped
to a workbench or worktable. The mounting board should be large enough to
prevent the variable speed scroll saw from tipping while in use and be a minimum
19mm thickness is recommended.
note:
It may be necessary to countersink the bolt head on the bottom side of
mounting board.
reducing noise and vibration
By placing foam pad or a piece of carpet between the variable speed scroll saw
and the workbench to further reduce noise and vibration. The size should be
approximately 610mm x 305mm x 13mm thick. If padding is to be used do not
overtighten the mounting bolts.
•
•
•
