DESCRIPTION OF SYMBOLS
THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR YOUR
BATTERY CHARGER.
•
To reduce risk of damage to the electric plug and cord, pull by the plug rather than the cord when
disconnecting the charger.
•
Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise subjected
to damage or stress.
•
DO NOT store or use the tool in locations where the temperature may reach or exceed 40ºC (such as
inside sheds or metal buildings in summer).
•
The tool is not fully charged out of the carton. First read the safety instructions and then follow the
charging notes and procedures.
•
The longest life and best performance can be obtained if the tool is charged when the air tempera-
ture is between 18 - 24ºC. Do not charge the tool in an air temperature below 10ºC or above 40ºC.
This is important and will prevent damage to the tool.
•
Do not incinerate the tool even if it is seriously damaged or is completely worn out. The battery can
explode in a fire.
•
Never attempt to open the tool for any reason. If the plastic housing of the tool breaks or cracks, im-
mediately discontinue use and do not recharge.
•
During charging, the tool must be placed in a well ventilated area.
BATTERY AND CHARGER SAFETY WARNINGS
Warning
Read instruction manual
mA Milliamperes
Polarity
Thermal cut-out protection
/min Revolutions or
reciprocation per minute
Ah
Amp hour
Indoor use only
Nm Newton Meters
n
o No load speed
V
Volts
Hz
Hertz
ac/~ Alternating current
W
Watts
Direct current
dc/
Isolation transformer
