OPERATION
9
Starting the Shredder
WARNING!
Prior to starting the motor ensure the shredder is empty.
Ensure you wear safety gloves, safety glasses and earmuffs when the
shredder is in use.
1. Connect the power cord (6) to an appropriate
extension cord and plug the extension cord into the
mains power point (Fig. 9).
2. To start the shredder move the on/off switch (4) to the
"on" position (Fig. 10).
3. To stop the shredder move the on/off switch (4) to the
"off" position (Fig. 10).
4. Remove the switch disabling insert to prevent
unauthorised use. Store the insert in a secure location
out of reach of children (Fig. 11).
Overload Protection
1. The shredder is equipped with a built in motor protection system that prevents
the motor from being overloaded. The motor will switch off automatically in
the event of overloading.
2. If overloading occurs wait 1-5 minutes and allow the motor to cool down
before restarting the shredder.
3. Move the on/off switch (4) to the "off" position before pressing the reset
button (5).
4. Press the reset button (5) (Fig. 12) and restart
the shredder.
5. If the shredder motor does not restart disconnect
from the mains power supply.
Note:
Refer to cleaning out plate hopper section
or troubleshooting.
Fig. 9
Fig. 10
Fig.12
!!
Fig. 11
RSH-100 Manual.qxd 1/11/11 1:01 PM Page 10
Summary of Contents for RSH-100
Page 1: ......