4. CONTROLS
WARNING!
ENSURE THE TOOL IS SWITCHED OFF AND
THE BATTERY IS REMOVED BEFORE PERFORMING ANY
OF THE FOLLOWING TASKS.
WARNING!
AFTER USE, HOLD THE SAW AWAY FROM
YOUR BODY UNTIL THE BLADE STOPS COMPLETELY.
3. DEPTH & BEVEL ADJUSTMENT
Depth Adjustment
Bevel Adjustment
3 Tighten depth
adjustment knob to
secure in place.
1 Loosen the depth adjustment
lever.
1 Loosen bevel adjustment knob.
3 Tighten the bevel adjustment
knob.
2 Hold the baseplate down with
one hand. Raise or lower the saw
to the desired depth.
2 Align baseplate to desired angle
on bevel scale.
Depth should be adjusted so that no more than one tooth is protruding
through the timber. This helps to minimise splintering.
Turning On and Off
2 Squeeze the on/off
trigger to start the
saw.
Note:
Allow the saw to reach full speed before beginning a cut.
1 Press and hold the lock-off level
in either direction.
3 To stop the saw, release the on/
off trigger.
The cutting guide will give an approximate line of cut. For a straight cut, use
the 0° notch. For a 45° cut, use the 45° notch. For higher accuracy, use the rip
fence provided.
Cutting Guide Notch
0
o
45
o
