2. BATTERY & CHARGING
(SOLD SEPARATELY)
CAUTION:
THE CHARGER FOR THIS PRODUCT
SHOULD BE PROTECTED BY A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS).
The purchased battery will be shipped in a low charge condition, and requires charging
prior to use. Allow several cycles of charging and discharging (through use of the tool)
for the battery to reach its optimum performance / runtime.
1. Connect the charger into a mains power outlet.
4. The charger LED will illuminate
red signifying that the battery is
charging.
3. With the charger sitting on a flat
surface, align the raised ribs on
the battery with the recess in the
charger and slide onto the charger
ensuring a firm connection.
2. The charger LED will flash green
showing power is being supplied
to the charger.
5. The charger LED will illuminate
green once the battery is charged.
Charging your lithium ion battery - Fast Charger
Charger LED Indicator
LED Indicator
Situation
GREEN (Flashing)
Stand By (no battery pack is inserted).
RED (Flashing)
Battery is charging (low charge).
RED (Illuminated)
Battery is charging (mid charge).
GREEN (Illuminated)
Battery is charged.
BOTH(Illuminated)
Battery pack is too hot or too cold (charging will begin
automatically when battery reaches correct charging
temperature).
BOTH (Flashing)
Defective battery. Never charge a defective battery
pack!
Remove battery pack from charger.
Attaching the Collection Bag
2. Attach the plastic connector on
the collection bag to the outlet
in the motor housing. Ensure the
tab clicks into the hole of the
connector.
1. Attach the clip on the collection
bag to the hook underneath the
upper tube.
3. Place the plastic connector on the
collection bag to the hook on the
motor housing.
Fitting the Shoulder Strap
1. Unscrew the knurled nut on the
shoulder strap hook and place
the strap through the gap.
2. Re-tighten the knurled nut on the
shoulder strap hook and adjust
the length as required.
Note:
To use the shoulder strap simply slide the strap over your shoulder
so that some of the weight of the blower vac can be taken by your
shoulder.
Attaching the Auxiliary Handle
1. Place the handle over the motor
housing so it is positioned
correctly.
2. Insert the bolt and secure turning
clockwise. Do not overtighten.