WARNING:
BEFORE CLEANING YOUR BLOWER VAC
OR CARRYING OUT ANY MAINTENANCE PROCEDURE,
MAKE SURE THE BATTERIES ARE REMOVED TO PREVENT
ACCIDENTAL STARTING.
MAINTENANCE
TROUBLESHOOTING
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long service
life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload, then pull the
switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use or immediately
after using the tool.
Cleaning and storing
• There are no user serviceable parts in the blower vac; if a fault is suspected, return
the blower vac to a power tool repairer.
• Keep air intake clean and air vents free from debris to avoid overheating the motor.
• Do not use cleaning agents to clean the plastic parts of the blower vac. A mild
detergent on a damp cloth is recommended. Water must never come into contact
with the blower vac.
• If the blower vac vibrates abnormally, stop motor immediately. Abnormal vibration
usually indicates a mechanical problem continued operation could lead to injury or
damage.
• No lubrication is necessary as the motor is equipped with lifetime-lubrication
bearings.
• Keep the ventilation vents of the blower vac clean at all times, if possible, prevent
foreign matter from entering the vents.
• After each use, blow air through the blower vac housing to ensure it is free from
all dust particles which may have built-up. Build up of dust particles may cause the
blower vac to overheat and fail.
• If the enclosure of the blower vac requires cleaning do not use solvents but a moist
soft cloth only. Never let any liquid get inside the blower vac; never immerse any part
of the blower vac into liquid.
• When not in use, the blower vac should be stored in a dry, frost free location not
within the reach of children.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
the repair of the blower vac by an unauthorised person or by mishandling of the blower
vac. This tool is designed for DIY use - use in commercial or industrial environments
will void the warranty.
Problem
Cause
Remedy
Poor Suction
Collection bag full
Empty the collection bag.
Clogged air tubes
Remove any debris or built
up within the upper and
lower tubes.
Clogged collection
bag connector
Remove the collection bag,
remove build up of debris
from connector & outlet in
the housing.
LED lights do not illuminate on charger
Check the charging adaptor is securely plugged into the wall outlet.
Check the battery is firmly connected to the charging cradle.
Check that the charging jack is securely connected to the charging cradle.
The battery has a short run time
Ensure the battery is properly charged. It will take 4-5 charging cycles before the battery
reaches optimum charge and run time.
Sparking visible through the housing air vents
A small amount of sparking may be visible through the housing vents. This is normal and
does not indicate a problem.