3. INSTALLATION
Connecting the Discharge Outlet
1. Insert hose adaptor
and an o-ring into
one of the collars.
2. Screw the adaptor and collar
tightly onto the pump outlet in
a clockwise direction to secure
in place.
Note:
Teflon tape (not supplied) is
recommended on threads
to ensure a water tight seal
and prevent any leakage.
The pump has 1 outlet (50.8mm), which allows for smaller outlet (25.4
or 40mm connector) size to be used to pump water, however this will
result in lower pressure and flow rate.
2. CONNECTING THE OUTLET
NOTE:
TO USE THE PUMP IN PERMANENT INSTALLATIONS
WITH RIGID PIPES, INSTALL A NON-RETURN VALVE TO AVOID
THE FLUID BEING RE-CIRCULATED ONCE THE PUMP HAS
STOPPED.
WARNING!:
ALL CONNECTIONS MUST BE AIR TIGHT,
FAILURE TO DO SO MAY RESULT IN AN AIR LEAK
WHICH CAN PREVENT THE PUMP FROM PRIMING.
1. Ensure the pump is mounted to a rigid base or ground.
26m
6.5m
MAXIMUM DELIVERY HEIGHT
WATER LEVEL
WARNING!:
ALWAYS CARRY OR LIFT THE PUMP BY THE
FRAME TO AVOID DAMAGING THE UNIT.
WARNING:
THIS PRODUCT IS INTENDED FOR PUMPING
WATER IN A HOME DOMESTIC APPLICATION. DO NOT
USE IT FOR CORROSIVE, ABRASIVE, EXPLOSIVE OR
DANGEROUS LIQUIDS.
2. Ensure the distance from the surface of the water to the pump inlet
does not exceed 6.5m.
3. Ensure the distance from the pump to the highest point that you
wish to deliver the water does not exceed 26 metres.
Before starting, perform a few simple checks:
WARNING!
ENSURE THE OUTLET FOR THIS PUMP,
INCLUDING ANY HOSES OR PIPES ARE NOT RESTRICTED
OR OBSTRUCTED IN ANY WAY. TAPS, VALVES AND ANY
TYPE OF TRIGGER NOZZLE MUST NEVER BE USED WITH
THIS PUMP. FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY RESULT IN PUMP FAILURE OR SERIOUS INJURY.
