ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
8. On/Off Switch
9. Oil Fill Plug
10. Oil Drain Plug
11. Priming Cap
12. Discharge Outlet
13. Suction Inlet
14. Drain Screw
6.3HP
1. CONNECTING THE INLET
WARNING!
ENSURE THE ENGINE IS SHUT OFF AND
THE ON/OFF SWITCH IS IN THE OFF POSITION BEFORE
PERFORMING ANY OF THE FOLLOWING ASSEMBLY.
Connecting the Suction Inlet
1. Place the filter
assembly into the
intake end of a
suction hose (not
included) and secure
with a hose clamp
tightly.
2. Insert a 50.8mm
hose adaptor and an
o-ring into one of the
collars and fasten to
the outlet side of the
suction hose using a
hose clamp.
3. Screw the hose adaptor and
collar tightly onto the pumps
inlet in a clockwise direction to
secure in place.
Note:
Teflon tape (not supplied) is
recommended on threads
to ensure a water tight seal
and prevent any leakage.
The inlet allows for a 50.8mm (2”) supply line to be connected and is
capable of a maximum suction height of 6.5m.
WARNING!:
AVOID POSITIONING THE INLET PIPE
HIGHER THAN THE PUMP, AS THIS WOULD DELAY THE
ESCAPE OF AIR BUBBLES FROM THE INLET PIPE.
WARNING!:
THE INPUT HOSE OR PIPE SHOULD BE
LOW ENOUGH IN THE WATER TO ENSURE THAT IF THE
WATER LEVEL FALLS, THE PUMP WILL NOT RUN DRY.
ENSURE THAT THIS IS CHECKED WHEN IN OPERATION.
15. Screwdriver
16. Spark Plug Wrench
17. Filter, 50.8mm Barb
18. Collars
19. O-rings
20. Hose Adaptor 25.4mm
21. Hose Adaptors 40mm
22. Hose Adaptors 50.8mm
23. Hose Clamps 50.8mm
24. Funnel
KNOW YOUR PRODUCT
SETUP & PREPARATION
PETROL TRANSFER WATER PUMP
ACCESSORIES
1
11
6
2
12
15
7
3
13
16
8
4
14
17 18 19 20 21 22 23 24
9
5
10
1. Air Filter
2. Throttle Lever
3. Choke Lever
4. Fuel Lever
5. Recoil Starter
6. Fuel Cap
7. Fuel Tank
