7
ADDITIONAL SAFETY INSTRUCTIONS FOR SHREDDERS
This appliance is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Recommendations for the use of a residual current device
with a rated residual
current of 30mA or less.
• Only operate the machine in open space (eg. not close to a wall or other fixed
object) and on a firm, level surface.
• Do not operate the machine on a paved or gravel surface where ejected material
could cause injury.
• Before starting the machine, look into the feeding chamber to make certain that it
is empty.
• Keep your face and body away from the feed intake opening.
• Always stand clear of the discharge zone when operating this machine.
• Do not transport this machine while the power source is running.
• Do not tilt the machine while the power source is running.
• When the machine is stopped for servicing, inspection, or storage, or to change an
accessory, shut off the power source, disconnect the spark plug wire from the spark
plug (electric unit disconnect from supply), make sure that all moving parts have
come to a complete stop and, where a key is fitted remove the key. Allow the
machine to cool before making any inspections, adjustments, etc.
• Only use the shredder in dry conditions and never outdoors when it is raining.
• Do not allow children or any person who has not read this instruction manual or
who is not familiar with the shredder operate the product.
• Remember that the operator may be held responsible for accidents or hazards
occurring to other people and/or their property.
• Ensure the shredder is placed on a firm and level surface prior to using.
• Never use the shredder with damaged safety devices or without protection.
• Wear ear protection when operating the shredder.
• Do not allow processed material to build up in the discharge chute. This may prevent
proper discharge and can result in kickback of material through the feeding hopper.
• If the machine becomes clogged, switch off the machine and disconnect from the
power. Allow the cutter to come to a stop. Clear debris from the cutter assembly.
• Never attempt to shred bones, stone, glass, metals, plastic or rags.
• Wear protective gloves, safety glasses and avoid loose clothing.
WARNING!
Rotating cutter head. Keep hands and feet out of openings
• Store shredder upright in a dry place when not in use.
• Never put your hands in the cutter area while the cutter assembly is running or the
shredder is plugged in. The cutter continues to run for a few seconds after the
shredder has been switched off.
• If the cutter strikes any foreign objects or if the shredder starts making any unusual
noise or vibration, switch off the shredder immediately and disconnect the power.
Allow the cutter to come to a stop and take the following steps:
- Inspect for damage.
- Check and tighten any loose parts.
- Have any damaged parts replaced and /or repaired by an electrician or power
tool repairer.
• Always switch off the shredder and disconnect the power whenever you leave the
work area.
!
