OPERATION (cont.)
10
Direction Control Switch
WARNING!
The direction control switch can only be used when the
shredder is turned off.
1. Prior to operation the direction control switch (3) must be set either to the feed
i
or reverse
h
position.
2. When set to the feed
i
position the shredder will pull
material through the hopper, into the rolling cutter head
and shred it (Fig. 11).
3. When set to the reverse
h
position the shredder will
run in the opposite direction and release any blocked
or clogged material (Fig. 12).
Note:
The direction control switch will not start the motor,
it only sets the direction of the rolling cutter head.
Starting the Shredder
WARNING!
Prior to starting the motor ensure that the shredder is empty.
1. Connect the shredder power cord to an appropriate extension cord and plug
the extension cord into a mains power point.
2. Set the direction control switch (3) to either the feed
i
or reverse
h
position.
3. To start the shredder press the green “I” button on
the on/off switch (1) (Fig. 13).
4. To stop the shredder press the red “O” button on the
on/off switch (1) (Fig. 14).
WARNING!
Do not feed material into the
shredder after the shredder has been stopped,
this can lead to material being trapped in the
shredder and make it very difficult to remove.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
!
!
!
