MAINTENANCE
6. CHANGING THE CUTTING BLADE
7. GENERAL MAINTENANCE
1. Lay the petrol edger on its side
with the cutting blade facing
up.
NOTE:
The cutting blade rotates
in anti-clockwise direction.
2. Hold the spindle in place with
supplied hex key. Use the
supplied spanner to remove
the flange nut, by turning in an
anti-clockwise direction.
3. Remove the flange nut, and
blade.
NOTE:
Ensure that the inner
flange and outer flange nut are
clean of any dirt or grass prior to
fitting.
4. Fit the new blade over the
inner flange.
5. Fit the flange nut and tighten
firmly using the open spanner
supplied, in a clockwise
direction. Use a 8mm hex key
to stop the spindle rotating.
• Keep the ventilation vents of the tool clean at all times, if
possible, prevent foreign matter from entering the vents.
• After each use, blow air through the engine housing to ensure
it is free from all dust particles which may build up. Build up of
dust particles may cause the unit to overheat and fail.
• If the enclosure of the tool requires cleaning do not use
solvents but a moist soft cloth or soft brush only. Never let any
liquid get inside the tool; never immerse any part of the tool
into a liquid.
NOTE:
Ozito Industries will not be responsible for any damage
or injuries caused by the repair of the tool by an unauthorised
person or by mishandling of the tool.
Air filter
1. Loosen the filter cover knob and
remove the filter cover.
2. Remove the air filter, brush off any dry
particles, or dislodge them by tapping
the air filter on a hard surface.
3. Replace the air filter, air filter cover
and air filter cover locking knob.
Replacing the spark plug
When the Petrol Edger will not start and everything has been
checked, it is likely the spark plug will need replacing. The spark
plug is not covered under warranty.
To replace the spark plug:
1. Pull the spark plug lead off the end of
the spark plug.
2. Loosen (anti-clockwise) the spark plug
using the larger socket side of the
spark plug spanner provided.
3. Remove the spark plug and replace
with a new one, as specified.
Spark plug:
LD BM6A.
4. Secure the spark plug in position
by tightening (clockwise) the spark
plug using the spark plug spanner
provided.
5. Fix the spark plug lead back to the
end of the spark plug ensuring it clicks
into place.
WARNING!:
BEFORE CLEANING YOUR PETROL
EDGER OR CARRYING OUT ANY MAINTENANCE
PROCEDURE, MAKE SURE THAT THE ENGINE IS OFF
AND IS COOL. DISCONNECT THE SPARK PLUG TO
PREVENT ACCIDENTAL STARTING
CUTTING EDGE
CUTTING EDGE
LOOSEN TIGHTEN
