3. ADJUSTING CUTTING DEPTH
2. FUEL
WARNING!:
PETROL IS VERY FLAMMABLE. AVOID
SMOKING OR CAUSING ANY SPARKS OR FLAMES
NEAR FUEL. MAKE SURE THAT YOU STOP THE ENGINE
AND ALLOW IT TO COOL BEFORE REFUELLING THE
PETROL EDGER. SELECT AN OPEN OUTDOOR AREA
FOR FUELLING AND MOVE AT LEAST 3M AWAY FROM
THE FUELLING POINT BEFORE STARTING THE ENGINE.
Engine fuel: mix at 40:1 only
NOTE:
Only use oil that is expressly labelled for use with air-
cooled 2-stroke engines.
NOTE:
Always transport and store fuels in
an approved container (supplied bottle is for
mixing only).
1. Fill with unleaded petrol (91 octane) up
to fuel line.
2. Add 2-stroke oil up to oil line. Shake
sufficiently for a thorough mix.
3. Fill the fuel tank to about 80% of its
capacity with the fuel mix.
Fuel tank capacity: 650ml
4. Fasten the fuel tank cap and
clean any spillage.
The edger has a height adjustment lever to easily adjust the
cutting height.
There are 5 settings ranging between -20 to 30mm.
1. To decrease the
cutting height pull the
height adjustment
lever out and move it
up a notch, towards
the handlebar.
2. To increase the cutting
height pull the height
adjustment lever out
and move it down a
notch, towards the
front of the unit.
NOTE:
If you are unsure
of which cutting height
to use, begin with a high
setting and complete a trial cut on a small section of the lawns
edge.
Readjust if necessary.
585.4ml
Regular
Unleaded
WARNING!:
NEVER ATTEMPT TO FUEL THE EDGER
IF THE FUEL SYSTEM COMPONENTS ARE
DAMAGED OR ARE LEAKING.
WARNING!:
ALLOW THE ENGINE TO COOL BEFORE
FUELLING. NEVER ATTEMPT TO REFUEL THE
ENGINE WHILE IT IS WARM OR STILL RUNNING.
WARNING!:
NEVER PLACE FLAMMABLE MATERIAL
CLOSE TO THE ENGINE MUFFLER.
