6. Tilt the unit backwards, so that
the blade is clear of the ground.
7. Release the safety then
squeeze the throttle gently.
Allow the engine to run for
60 seconds so that it warms up.
Stopping
1. When you wish to stop the
engine, first release the throttle
so that the engine is idling and
the blade stops spinning.
2. Press the On/Off switch to the
(O) Off position, as indicated on
the switch.
4. STARTING & STOPPING
OPERATION
Starting
NOTE:
Do not squeeze the throttle before starting.
1. Press the On/Off switch on the
handle to the On (I) position.
2. Press the primer bulb until full
of fuel
.
3. Push the choke lever up to the
Choke position.
NOTE:
Pressing the primer bulb
and setting the choke to the start
position is unnecessary if the engine
is warm
.
Cold Start position
.
4. Pull the recoil starter until the
engine starts.
5. Push the choke lever down
to the run position. Restart
i
if the engine stops.
Warm Start position
WARNING!:
THE LAWN EDGER RUNS FOR A FEW
SECONDS AFTER IT HAS BEEN SWITCHED OFF.
LET THE ENGINE COME TO A COMPLETE STANDSTILL
BEFORE SETTING THE TOOL DOWN.
1
2
